Removal Of The - Barco HDF W22 User And Installation Manual

16. Removal and installation of the projector covers
16.1 Removal of the front cover
W
ARNING
Necessary tools
7 mm flat screw driver.
How to remove the front cover
1. Remove the lens. See "Lens removal".
2. Remove the rubber dust ring from the lens holder.
3. Release the captive screw at the middle bottom of the front cover, using a flat screw driver.
Image 16-1
Captive screw
4. Remove the front cover from the projector as follows:
a) standing in front of the projector, pull the right side of the front cover toward you until the latches release (left side is hinged)
b) then slide the front cover to the right to release it from the hinging points.
Image 16-2
392
:
This procedure may only be performed by qualified technical service personnel.
R5905158 HDF SERIES 08/12/2016