Installation Process Overview - Barco HDF W22 User And Installation Manual

2.7

Installation process overview

Quick setup
The following steps describe briefly how to setup your HDF series projector in a table mount front projection. Note that each step
refers to a corresponding procedure, which is more detailed and illustrated.
1. Install the batteries of the remote control. See "RCU battery installation", page 31
2. Place the projector on a solid table in front of the screen at the expected throw distance. Ensure that the projector is installed at
right angles (horizontally and vertically) with the screen. See "Projector configurations", page 22.
3. Select and install an appropriate lens, which covers the throw ratio ( = screen size / projector screen distance). See "Lenses",
page 36.
4. Connect the projector with the local power net. See "Power connection", page 51.
5. Connect your source to the appropriate input module. See "Input source connections", page 57.
6. Switch ON the projector. See "Power on projector", page 67.
7. Select the input slot to which the source is connected. Do this by pressing the numeric key on the remote control unit or on the
local keypad, See "Source selection", page 77.
8. Zoom and shift the lens until the image is properly projected on the screen, Do this by using the "ZOOM" and "FOCUS" key on
the remote control unit or on the local keypad. If necessary, level the projector from side to side by turning the adjustable feet in
or out.
Check cooling liquid level at least every 6 months.
Every 6 months at device power up a message will be displayed on the local LCD to check the cooling liquid
level
R5905158 HDF SERIES 08/12/2016
2. Configurations, requirements and restrictions
27