Lens Safety Cable - Barco HDX 4K Series User Manual

Lenses & Lens selection
It's recommended to place the foam rubber of the original projector packaging, back into the Lens
opening to prevent intrusion of dust. Note that this foam rubber is packed in a plastic bag to prevent
the dust, emitted by the foam, from entering the projector.

5.5 Lens safety cable

When using the safety cable ?
The lens safety cable must be used in any circumstances to protect a mounted lens in the lens holder when
the projector is mounted above persons.
Configuration differences
There are two different configurations for the safety cable. The configuration used depends on the used
carrying handle or hoisting eye.
• Configuration A applies when connecting the projector to the bottom carrying handle.
• Configuration B applies when connecting the projector to the top carrying handle.
Required parts
• Safety Cable (750 mm, Ø3 mm)
• Cable clamp M4
• Shackle 7x70 mm
• 4 x Cable clip (16x16 mm, Ø4 mm)
How to mount the cable
1. Paste four cable clips on the lens as illustrated (reference 1). Orient the open side of the clips towards the front
of the lens.
52 R5906070-11 HDX 4K