Controlling The Projector - Barco HDF W22 User And Installation Manual

5. Getting started
5.8.2

Controlling the projector

Projector address
Address installed in the projector to be individually controlled.
Common address
Projector will always execute the command coming from a RCU programmed with that common address.
Why a projector address ?
As more than one projector can be installed in a room, each projector should be separately addressable with an RCU or computer.
Therefore each projector has its own address.
Set up an individual Projector Address.
The set up of a projector address can be done via the software. See chapter 'Projector Control', 'Projector address'.
Projector controlling.
Every projector requires an individual address between 0 and 255 which can be set in the Service mode.
When the address is set, the projector can be controlled now:
• RCU for addresses between 0 and 9.
• computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
Common Address
Every projector has a common address '0' or '1'. The choice between '0' and '1' can be selected in Projector Control → Projector
address → Common address.
76 R5905158 HDF SERIES 08/12/2016