16.8 Installation of the input cover
W
ARNING
Necessary tools
7 mm flat screw driver.
How to install the input cover
1. Install the input cover of the projector as follows:
a) Bring the input cover towards its final position (A),
b) then gently push the locking stud at the right top corner (B) into its receiver,
c) then gently push the locking stud at the right bottom corner (C) into its receiver.
A
Image 16-16
Input cover, installation
2. Secure the input cover by locking the two captive screws at the left side of the input cover.
Image 16-17
Captive screws, locking
R5905158 HDF SERIES 08/12/2016
:
This procedure may only be performed by qualified technical service personnel.
16. Removal and installation of the projector covers
B
C
399