Clo Mode (Constant Light Output Mode) - Barco HDF W22 User And Installation Manual

11. Lamp

11.7 CLO mode (Constant light output mode)

What can be done?
Constant Light Output allows to force a constant light output (set in the CLO Target lumens item) of the projector over a certain
period. This will eliminate uncontrolled light output drop caused by natural aging of the lamp. The light output is checked every 5
minutes, if the target is not met, the lamp power is adjusted.
Setting CLO off means that the lamp will operate at constant power (no power adaptation to meet constant light output).
In the illustration below, a normal light output curve is shown over the first 1000 hours, image 11-16. By using CLO and setting the
target to 60% of the maximum light output, one will be able to operate during approximately 500 hours with a constant light output,
image 11-17.
Relative Light Output (%)
100
80
60
40
20
Image 11-16
Relative Light Output (%)
100
80
60
40
Constant Light Output
working area
20
Image 11-17
CLO mode setting On overrules the lamp power mode setting. Projector will always play in CLO mode using
the CLO target.
How to switch CLO mode
1. Press Menu to activate the menus and select Lamp → Power → CLO mode.
Image 11-18
Main menu, lamp
214
200 400 600
200 400 600
800 1000
800 1000
Image 11-19
Lamp, power
Runtime (hrs)
Runtime (hrs)
R5905158 HDF SERIES 08/12/2016