Lens Removal; Lens Safety Cable - Barco HDF Use And Installation Manual

3. Physical installation
3.2.4

Lens removal

How to remove
Support the lens with one hand while you unlock the lens holder by sliding the lock handle towards the "unlocked" position as illus-
trated.
Image 3-21
Lens removal, unlock
Gently pull the lens out of the lens holder.
Image 3-22
Lens removal
It's recommended to place the Lens caps of the original Lens packaging, back on both sides of the removed
Lens to protect the optics of the Lens.
It's recommended to place the foam rubber of the original projector packaging, back into the Lens opening to
prevent intrusion of dust. Note that this foam rubber is packed in a plastic bag to prevent the dust, emitted by
the foam, from entering the projector.
3.2.5

Lens safety cable

When using the safety cable ?
The lens safety cable must be used in any circumstances to protect a mounted lens in the lens holder.
How to mount the cable
Put the safety cable around the lens. Make sure the cable is mounted between the motor part and the mounting flange
28 R5905158 HDF SERIES 16/06/2015