Linearity Adjustment, Workflow - Barco HDF W22 User And Installation Manual

12. Alignment
12.8.9 Linearity adjustment, workflow
Adjusting vertical and horizontal linearity
1. Select the 2 x 2 adjustment level. See "Setting the warping level", page 237.
The default selected anchor point is the left top corner of the image.
2. Select the desired warp area.
Depending on the selected area only the points in that area will be adjusted.
3. Select Linearity.
4. Select within Warp Adaptations, Horizontal or Vertical to adjust the corresponding keystone.
Or,
press ENTER when an item is selected and use the 4 arrow keys to adjust.
Image 12-45
Warping, Linearity
5. Adjust the horizontal and vertical linearity.
To fine tune this adjustment, select a specific area and add extra anchor points by changing the warp level.
242 R5905158 HDF SERIES 08/12/2016