Table of Contents
Advertisement
Starting / Quitting Cutting
Setting the Origin Point
With this machine, you can set the location where cutting starts (the origin point) at any position. If the default
origin point just after setup (pressing
origin point. Setting the origin point at the point you want on the material lets you start cutting at any location
you like, which can help reduce wasted material.
Procedure
2
Press
want to set the origin point.
Hold down
The origin point has been set.
Material Test Feed
Perform test feed beforehand to ensure that the roll material is not pulled with undue force during cutting.
If the roll material is pulled with undue force during cutting, a motor error may occur, or the position may be
displaced. Test feed can also be performed to make sure that the loaded material is straight. Using the [AREA]
feature makes it simple to perform test feed for the required portion. Make sure that the type of the material
has been selected using the operation panel and that material loading has been completed.
Procedure
Make sure the brake is released.
Press
40
) is acceptable, there is no need for you to explicitly set the
for 0.5 seconds or longer.
Press
figure appears.
Press
Press
Press
figure appears.
Press
Press
material length.
Set the length that is about 0.2 m longer than the required material length.
(A positive value signifies material feed toward the front, and a negative
value signifies material feed toward the back. If you are performing front
loading, set the length to a negative value.
P. 57, "Front Loading"
to start the test feed.
Press
to move the blade to the location where you
several times until the screen shown in the
.
.
several times until the screen shown in the
.
to make the setting for the required
go back to the screen shown in the figure.
Advertisement
Table of Contents
