When Performing Long Cutting - Roland Camm-1 CX-24/12 User Manual

4 Basic Operation

4-5 When Performing Long Cutting

Cutting a length of 1.5 m (59 in.) or more requires
material that is at least 50 mm (2 in.) wider than the
necessary cutting width.
1 Refer to the figure at right and move the pinch rollers.
Position the pinch rollers so that each one is 25 mm (1
in.) from the respective left or right edge of the
material.
2
Raise the sheet loading lever to secure the material in
place.
3
Before performing material feed, pull out the required
length of material from the roll material.
4
Refer to the previous section,
Feed," and perform material feed.
If the material comes loose, then reload the material.
"4-4 Checking Material
24
Prepare material that is at least
50 mm (2 in.) wider than the
necessary cutting width.
25 mm
(1 in.) or more
25 mm
(1 in.) or more