CHAPTER 13
Initially Configuring the Switch
OCX1100 Default Configuration
Copyright © 2017, Juniper Networks, Inc.
OCX1100 Default Configuration on page 91
Connecting and Configuring an OCX1100 Switch (CLI Procedure) on page 100
Each OCX1100 switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when the switch is shipped. The default
configuration file sets values for system parameters such as
Ethernet switching on all interfaces, enables IGMP snooping, and enables the LLDP and
RSTP protocols.
The following default configuration file is for an OCX1100 switch:
NOTE:
Interfaces ge-0/0/1 through ge-0/0/48 are SFP+ port interfaces.
Interfaces ge-0/0/49 through ge-0/0/54 are QSFP+ port interfaces.
When you commit changes to the configuration, a new configuration file is created, which
becomes the active configuration. You can always revert to the factory default
configuration.
system {
commit {
factory-settings {
reset-virtual-chassis-configuration;
reset-chassis-lcd-menu;
}
}
processes {
app-engine-virtual-machine-management-service {
traceoptions {
level notice;
flag all;
}
}
}
}
interfaces {
xe-0/0/1 {
and
, configures
syslog
commit
91