Figure 24: Installing An Ac Power Supply In An Ocx1100-48Sx Switch - Juniper OCX1100 Hardware Manual

OCX1100 Switch Hardware Guide

Documentation

NOTE:

Each power supply must be connected to a dedicated power source

outlet.

To install an AC power supply in the switch:

Ensure that you have the correct power supply. The label

(AFO)

on the power supply must match the label

the installed fan module.

Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD

point on the chassis.

If the power supply slot has a cover panel on it, loosen the captive screws on the cover

panel by using your fingers or a screwdriver. Hold the captive screw and gently pull it

outward to remove the cover panel. Save the cover panel for later use.

Taking care not to touch power supply pins, leads, or solder connections, remove the

power supply from the bag.

Using both hands, place the power supply in the power supply slot on the rear panel

of the switch and slide it in until it is fully seated and the clip clicks into place. See

Figure 24 on page

78.

Figure 24: Installing an AC Power Supply in an OCX1100-48SX Switch

NOTE:

If you have a Juniper J-Care service contract, register any addition,

change, or upgrade of hardware components at

https://www.juniper.net/customers/support/tools/updateinstallbase/

to do so can result in significant delays if you need replacement parts. This

note does not apply if you replace existing components with the same type

of component.

Removing an AC Power Supply from an OCX1100 Switch on page 111

AC Power Supply in OCX1100 Switches on page 23

AIR IN (AFI)

AIR OUT

AIR IN (AFI)

AIR OUT (AFO)

. Failure

Table of Contents