OCX1100 Switch Hardware Guide
Table 33: Console Port Connector Pinout Information (continued)
Pin
Signal
7
CD Input
8
CTS Input
Related
Documentation
Mini-USB Port Pinout Specifications
Table 34: Mini-USB Type-B Console Port Pinout Information
Pin
Signal
1
VCC
2
D-
3
D+
X
N/C
4
GND
Related
Documentation
RJ-45 Management Port Connector Pinout Information
56
Description
Data carrier detect
Clear to send
Connecting a Device to a Management Console by Using an RJ-45 Connector on page 86
Configuring the Console Port Type (CLI Procedure)
If your management host (laptop or PC) does not have a DB-9 male connector pin or an
RJ-45 connector pin but has a USB port, you can connect your management host to the
Mini-USB Type-B console port by using a cable that has a standard Type-A USB connector
on one end and a Mini-USB Type-B (5-pin) connector on the other end.
The Mini-USB Type-B console port uses a Mini-USB Type-B connector to connect to a
console management device. The default baud rate for the console port is 9600 baud.
Table 34 on page 56
provides the pinout information of the Mini-USB Type-B console
port.
Description
+5 VDC
Data -
Data +
Could be not connected (N/C), connected to ground (GND), or used as an attached device
presence indicator
Ground
Management Cable Specifications on page 53
Table 35 on page 57
provides the pinout information for the RJ-45 connector for the
management port on Juniper Networks devices.
Copyright © 2017, Juniper Networks, Inc.