Advertisement
OCX1100 Switch Hardware Guide
Packing an OCX1100 Switch for Shipping
132
If you need to transport the switch to another location or return the switch to Juniper
Networks, you need to pack the switch securely in its original packaging to prevent damage
during transportation.
Before you pack the switch:
On the console or other management device connected to the switch, enter the CLI
1.
operational mode and issue the following command to shut down the switch software:
user@switch> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
Disconnect power from the switch by performing one of the following:
2.
If the power source outlet has a power switch, set it to the off (
If the power source outlet does not have a power switch, gently pull out the male
end of the power cord connected to the power source outlet.
Remove the cables that connect the switch to all external devices. See
3.
a Fiber-Optic Cable from a Device" on page
Remove all optical transceivers installed in the switch. See
4.
on page
119.
Ensure that you have the following parts and tools available to pack the switch:
Phillips (+) screwdriver, number 2
The original switch packing material (cardboard box, accessory box and its contents,
and foam padding)
ESD grounding strap
Antistatic bag
CAUTION:
Do not pack the switch in anything except its original container or
the switch might be damaged in transit.
To pack the switch:
If the switch is installed in a rack or cabinet, have one person support the weight of
1.
the switch while another person unscrews and removes the mounting screws.
Remove the switch from the rack or cabinet and place the switch on a flat, stable
2.
surface.
) position.
0
"Disconnecting
124.
"Removing a Transceiver"
Copyright © 2017, Juniper Networks, Inc.
Advertisement
Chapters
