Installing A Dc Power Supply In An Ocx1100 Switch; Figure 37: Removing An Ac Power Supply From An Ocx1100-48Sx Switch - Juniper OCX1100 Hardware Manual

OCX1100 Switch Hardware Guide

Documentation

Installing a DC Power Supply in an OCX1100 Switch

112

Press the clip to the left and grasp the power supply handle and pull firmly to slide

the power supply halfway out of the chassis.

Place one hand under the power supply to support it and slide it completely out of

the chassis. Take care not to touch power supply components, pins, leads, or solder

connections.

Place the power supply in the antistatic bag or on the antistatic mat placed on a flat,

stable surface.

If you are not replacing the power supply, install the cover panel over the slot.

Figure 37 on page 112

shows how to remove an AC power supply from an OCX1100 switch.

Installing an AC Power Supply in an OCX1100 Switch on page 77

Installing and Removing OCX1100 Switch Hardware Components on page 74

AC Power Supply Specifications for OCX1100 Switches on page 41

Field-Replaceable Units in OCX1100 Switches on page 12

AC Power Cord Specifications for an OCX1100 Switch on page 41

OCX1100 Switches Hardware Overview on page 3

The DC power supply in OCX1100 switches is a hot-removable and hot-insertable

field-replaceable unit (FRU) installed in the rear panel of the switch: You can remove

and replace it without powering off the switch or disrupting switch functions.

CAUTION:

Do not install:

AC and DC power supplies in the same chassis.

AC power supplies in DC switch models or DC power supplies in AC switch

models.

Table of Contents