Removing A Transceiver; Figure 40: Installing A Transceiver - Juniper OCX1100 Hardware Manual

Documentation

Removing a Transceiver

WARNING:

Do not look directly into a fiber-optic transceiver or into the

ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables

connected to transceivers emit laser light that can damage your eyes.

1— Ejector lever

Removing a Transceiver on page 119

Connecting a Fiber-Optic Cable on page 89

The transceivers for Juniper Networks devices are hot-removable and hot-insertable

field-replaceable units (FRUs): You can remove and replace them without powering off

the device or disrupting device functions.

NOTE:

After you remove a transceiver or when you change the media-type

configuration, wait for 6 seconds for the interface to display the operational

commands.

Before you begin removing a transceiver from a device, ensure that you have taken the

necessary precautions for safe handling of lasers (see

and Warnings" on page

155).

Ensure that you have the following parts and tools available:

An antistatic bag or an antistatic mat

Rubber safety caps to cover the transceiver and fiber-optic cable connector

A dust cover to cover the port

Figure 41 on page 121

shows how to remove a QSFP+ transceiver. The procedure is the

same for all types of transceivers except the CFP transceivers.

Chapter 16: Replacing Transceiver

"Laser and LED Safety Guidelines

119

Table of Contents