Advertisement
Copyright © 2017, Juniper Networks, Inc.
Parity—None
Stop bits—1
DCD state—Disregard
To connect and configure the switch from the console:
Connect the console port on the rear panel of the switch to a laptop or PC by using
1.
the RJ-45 to DB-9 serial port adapter. See
on page
3. You can also use the Mini-USB Type-B console port to connect to a laptop
or PC. See
"Connecting an OCX1100 Switch to a Management Console by Using the
Mini-USB Type-B Console Port" on page
Log in as root. There is no password. If the software booted before you connected to
2.
the console port, press the Enter key for the prompt to appear.
login root
Start the CLI.
3.
root@:RE:0% cli
Enter configuration mode.
4.
root> configure
Specify a password for the root administration user account.
5.
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
(Optional) Configure the name of the switch. If the name includes spaces, enclose
6.
the name in quotation marks (" ").
[edit]
root@# set system host-name host-name
Configure the default gateway.
7.
[edit]
root@# set routing-options static route default next-hop address
Configure the IP address and prefix length for the switch management interface.
8.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
(Optional) Configure the static routes to remote prefixes with access to the
9.
management port.
Chapter 13: Initially Configuring the Switch
"OCX1100 Switches Hardware Overview"
87.
101
Advertisement
Chapters
