United States; Fcc Part 15 Statement; Compliance Statements For Acoustic Noise For Ocx1100 Switches - Juniper OCX1100 Hardware Manual

OCX1100 Switch Hardware Guide

United States

Documentation

Documentation

184

The device has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in

a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual,

might cause harmful interference to radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference, in which case users need to

correct the interference at their own expense.

This equipment has been tested and found to comply with the limits for a Class A digital

device pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, might cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try

and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio or TV technician for help.

Agency Approvals for OCX1100 Switches on page 181

Compliance Statements for Acoustic Noise for OCX1100 Switches on page 184

Maschinenlärminformations-Verordnung - 3. GPSGV, der höchste Schalldruckpegel

beträgt 70 dB(A) oder weniger gemäss EN ISO 7779

Translation:

The emitted sound pressure is below 70 dB(A) per EN ISO 7779.

Agency Approvals for OCX1100 Switches on page 181

Compliance Statements for EMC Requirements for OCX1100 Switches on page 182

Table of Contents