Connecting The Switch To The Network; Connecting A Device To A Network For Out-Of-Band Management; Connecting A Device To A Management Console By Using An; Figure 28: Rj-45 Connector On An Ethernet Cable - Juniper OCX1100 Hardware Manual

CHAPTER 12

Connecting the Switch to the Network

Connecting a Device to a Network for Out-of-Band Management on page 85

Connecting a Device to a Management Console by Using an RJ-45 Connector on page 86

Connecting an OCX1100 Switch to a Management Console by Using the Mini-USB

Type-B Console Port on page 87

Connecting a Fiber-Optic Cable on page 89

You can monitor and manage these devices by using a dedicated management channel.

Each device has a management port to which you can connect an Ethernet cable with

an RJ-45 connector. Use the management port to connect the device to the management

device.

Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.

Figure 28 on page 85

shows the RJ-45 connector of the Ethernet cable supplied with the

device.

To connect a device to a network for out-of-band management (see

Figure 29 on page

86):

Connect one end of the Ethernet cable to the management port (labeled

) on the device.

ETHERNET

Connect the other end of the Ethernet cable to the management device.

MGMT

Table of Contents