I/O Configuration And Model Number Legend; I/O Configuration - Omron E5AC-T User Manual

1-2 I/O Configuration and Model Number
Legend
1-2-1

I/O Configuration

I/O Configuration of E5 C-T
Inputs
Input signals
Program control
SP
Set point (SP)
Program SP
Fixed SP
Potentiometer input
Process value (PV) input
• Thermocouple
• Resistance thermometer
• Input type
• Infrared Temperature Sensor
• Input filter
• Analog input (current/voltage)
• Extraction of square root • Analog scaling
• Run/Reset switching
Event inputs (EV1 to EV6)
• Program number switching
• External inputs
• Program SP Mode/Fixed SP
(contact or non-contact input)
Mode switching
• 100% AT execute/cancel
• Setting change
enable/disable
• Alarm latch cancel
• All PID 100% AT Execute/Cancel
• All PID 40% AT Execute/Cancel
Input voltage from CT
CT input
Setup Tool (CX-Thermo) Setting and monitoring
Power supply
A: 100 to 240 VAC
or
D: 24 VAC/DC
Note: Not all models support these functions. For details, refer to 1-2-2 Model Number Legends.
E5@C-T Digital Temperature Controllers User's Manual (H185)
E5 C-T
Control
SP mode
t
• Set point limiter
SP
FB
• Input shift
PV
• Moving average
• Hold/Clear Hold
• Auto/manual selection
• Invert direct/reverse
Automatic setting of
operation
PID constants with AT
• 40% AT execute/cancel
• Communications
• Standard control
write enable/disable
• Heating/cooling control
• Program No.
• Position-proportional control
• Advance
• Wait Enable/Disable
Alarms
• HB alarm
• HS alarm
Heating
Operation Open
Limits
Manipulated
value
• MV limit
• Direct/reverse
(MV)
• MV
• Auto/manual
rate-of-
change limit
Cooling
Close
Contact status
• Standard alarms (alarms 1 to 4)
• HB alarm
• HS alarm
• Input error (S.ERR)
• Integrated alarm
• RUN status
•
Program end
• Work bits 1 to 8
Analog status
• Present SP
• Process value
• Manipulated value
* Functions can be assigned individually for each output by
changing the set values for the Control Output 1 and 2
Assignments and the Auxiliary Output 1 to 4 Assignments in the
parameters in the advanced function setting level.
1 Introduction
1
Outputs
Output signals
• Linear current
Control output 1
• Voltage
(for driving SSR)
• Relay
*
• Linear current
Control output 2
• Voltage
(for driving SSR)
• Relay
*
Auxiliary outputs 1 to 4
• Relay
*
Transfer output
• Linear current
• Linear voltage
• CompoWay/F
Communications
• Modbus-RTU
• RS-485
1 - 5