Making The Initial Program-Related Settings - Omron E5AC-T User Manual

The parameter setting procedures for the example in 4-2 Initial Setup Examples through Starting Pro-
gram Operation are given starting on the next page.
4-7-4

Making the Initial Program-related Settings

Set the following parameters before you create the program.
Set the Program Time Unit parameter.
• Program Time Unit
Set the Step Time/Rate of Rise Programming parameter
(i.e., the program setting method).
• Step Time/Rate of Rise Programming
Set the Time Unit of Ramp Rate parameter (for rate of
rise programming).
• Time Unit of Ramp Rate
Set the Reset Operation parameter.
• Reset Operation
Set the Startup Operation parameter.
• Startup Operation
Set the Operation End Operation parameter.
• Operation End Operation
Set the SP Mode parameter (when the reset operation
is set to stop control).
• SP Mode
Setting the Program Time Unit Parameter
This parameter sets the time unit for execution of the program.
Related Parameters
Parameter name
Program Time Unit
Setting Example
The following example shows how to set hours and minutes.
Operating Procedure
1
Press the M Key several times in the Initial Setting Level to
select the Program Time Unit parameter.
2
Press the U or D Key to set hours and minutes
The default is hours and minutes.
E5@C-T Digital Temperature Controllers User's Manual (H185)
Display Setting range
t-u h-m: Hours and minutes
m-s: Minutes and seconds
4 Basic Operation
Initial Setting Level
Set the Program Time Unit parameter.
Set the Step Time/Rate of Rise Programming parameter.
Set the Time Unit of Ramp Rate parameter.
Set the Reset Operation parameter.
Set the Startup Operation parameter.
Set the Operation End Operation parameter.
Adjustment Level
Set the SP Mode parameter.
Default Level
h-m
Initial Setting Level
Initial Setting Level
t-u
Program
h-m
Time Unit
t-u
h-m
4
4 - 33