Omron E5AC-T User Manual page 122

Parameter
Segment Number
Elapsed Program Time
Remaining Standby Time
Program Repetitions
Hold Status
Auto/Manual
*1
Manual MV
Run/Reset
*1 For position-proportional models, the Direct Setting of Position-Proportional MV parameter must be set to
OFF.
*2 The remaining standby time is set in the Standby Time parameter.
*3 If Auto Mode was in effect when power was interrupted, the Manual MV will be 0 (OFF) if the Manual
Output Method parameter is set to HOLD (retain MV) and it will be the value of the Manual MV Initial
Value parameter if the Manual Output Method parameter is set to INIT (output initial value). However, if
the Manual Output Method is set to HOLD (remain MV) for position-proportional control, the manual MV
will be as follows:
• If the potentiometer input is normal: Valve Opening
• If there is a potentiometer input error and control is stopped: MV at Reset
• If there is a potentiometer input error and control is in progress: MV at PV Error
Related Parameters
Parameter name
Startup Operation
Setting Example
The following example shows how to set continuing from the previous status.
Operating Procedure
1
Press the M Key several times in the Initial Setting Level to
select the Startup Operation parameter.
2
Press the U or D Key to set Continue.
The default is Continue.
E5@C-T Digital Temperature Controllers User's Manual (H185)
Setting of the Startup Operation parameter
Continue
Retained.
Retained.
Retained.
Retained.
Retained.
Retained.
Retained.
Retained.
Display Setting range
p-on cont: Continue
rst: Reset
run: Run
manu: Manual Mode
4 Basic Operation
Reset Run
--- ---
--- ---
*2
---
---
--- ---
--- ---
Retained. Retained.
Retained. Retained.
--- ---
Default
cont
Initial Setting Level
p-on
p-on
Manual Mode
Retained.
Retained.
Retained.
Retained.
Retained.
---
*3
Retained.
Retained.
Level
Initial Setting Level
Startup Operation
cont
cont
4 - 37
4