Mounting - Omron E5AC-T User Manual

2-1-3

Mounting

E5CC-T
There are two models of Terminal Covers that you can use with the E5CC-T.
Waterproof packing
Mounting to the Panel
(1) For waterproof mounting, waterproof packing must be installed on the Controller.
Waterproofing is not possible when group mounting several Controllers. Waterproof
packing is not necessary when there is no need for the waterproofing function.
(2) Insert the E5CC-T into the mounting hole in the panel.
(3) Push the Adapter from the terminals up to the panel, and temporarily fasten the E5CC-T.
(4) Tighten the two fastening screws on the Adapter. Alternately tighten the two screws little by
little to maintain a balance. Tighten the screws to a torque of 0.29 to 0.39 N·m.
Mounting the Terminal Cover
Slightly bend the E53-COV23 Terminal Cover to attach it to the terminal block as shown in the following
diagram. The Terminal Cover cannot be attached in the opposite direction. Or, you can use the E53-COV17
Terminal Cover. Make sure that the "UP" mark is facing up, and then attach the E53-COV17 Terminal Cover to
the holes on the top and bottom of the Digital Controller.
E5@C-T Digital Temperature Controllers User's Manual (H185)
E53-COV17
Adapter
Terminal Cover
(Sold separately.)
Panel
• E53-COV17
Terminal Cover
(E53-COV17)
(Sold separately.)
Adapter
* The Terminal Cover is provided only with the
following models: E5CC-T@@@@5M-@@@.
Adapter
2 Preparations
E53-COV23
Terminal Cover*
• E53-COV23
Enlarged Illustration of
Terminal Section
2 - 5
2