Omron E5AC-T User Manual page 256

Program Tab Page
Use this tab page to set the parameters that are used by all segments in one program.
Parameter name
Number of Segments Used
PID Set No.
Program Repetitions
Program Link Destination
Alarm Value 1
Alarm Value 2
Alarm Value 3
Alarm Value 4
E5@C-T Digital Temperature Controllers User's Manual (H185)
Description
This parameter specifies the number
of segments in the program.
This parameter sets the PID set
number for the specified program
number.
This parameter is used to repeat the
program the specified number of
times.
This parameter sets the destination
after the program. Once a program
has been completed, the operation
will continue with the program
number specified for this parameter.
These parameters set the alarm
values for alarms 1 to 4 of the
specified program.
5 Advanced Operations
Controller Setting Level
Program Setting Level
Program Setting Level
Program Setting Level
Program Setting Level
Program Setting Level
5
Page
6-17
6-20
6-22
6-22
6-20
5 - 95