Omron E5AC-T User Manual page 324

tspu
This parameter sets the last SP for auto-tuning when auto-tuning all PID sets.
• You can set the last SP for auto-tuning when auto-tuning all PID sets.
• When you auto-tune all PID sets, auto-tuning is performed from the Fixed SP value to the
All PID AT Upper Limit SP value.
Function
• If the Fixed SP value is greater than or equal to the All PID Upper Limit SP value (for
normal operation, it must be less than or equal), auto-tuning is performed only for the
Fixed SP value.
SP Lower Limit to SP Upper Limit
Setting
Related Parameters
See See
PID ON/OFF (Initial Setting Level): Page 6-63
AT Execute/Cancel (Adjustment Level): Page 6-27
Fixed SP (Adjustment Level): Page 6-28
PID * Automatic Selection Range Upper Limit (PID Setting Level): Page 6-49
Set Point Upper Limit (Initial Setting Level): Page 6-58
Set Point Lower Limit (Initial Setting Level): Page 6-58
cntl
• This parameter selects 2-PID control or ON/OFF control.
• The auto-tuning function can be used in 2-PID control.
Function
Setting
Related Parameters
See
See
AT Execute/Cancel (Adjustment Level): Page 6-27
Manual Reset Value (Adjustment Level): Page 6-38
Hysteresis (Heating) and Hysteresis (Cooling) (Adjustment Level): Page 6-38
E5@C-T Digital Temperature Controllers User's Manual (H185)
All PID AT Upper Limit SP
Setting range
PID·ON/OFF
Setting range
pid: 2-PID, onof: ON/OFF
Control must be set to 2-PID control and the PID
Set Automatic Selection Data parameter must not
be set to DV (deviation).
Unit
EU
A Standard Model must be used.
Default
onof
6 Parameters
Default
0
6 - 63
6