Omron E5AC-T User Manual page 84

Operation Level Operation Level Program Setting Level Program Setting Level
25
0
Press O
(Level) Key
once.
Press M
(Mode) Key
once.
Press M
(Mode) Key
once.
Set the
parameters for
the one
program.
* In the default settings for models with HB or HS alarms, the Alarm Type 1 parameter is not displayed.
To enable alarm 1, assign it to an output. Refer to 4-6-3 Assigned Output Functions (Assigning Control
Outputs Is Not Supported for Position-proportional Models.) for details.
E5@C-T Digital Temperature Controllers User's Manual (H185)
d. p rg
d.prg (d.PRG) is displayed.
Indicates that you entered the Program Setting Level.
0
Select program number 0.
Press M
(Mode) Key
once.
s-no.
s-no. (S-No.): Change the number of
segments used from 8 to 4.
Press D
Key.
d. s eg
d.seg (d.SEG):
Display Segment
end
Selection
In the end status, press
M (Mode) Key to set
the parameters for the
one program.
pid
pid (PID): PID set number
1
al-1
al-1 (AL-1): Alarm Value 1*
3 Part Names and Basic Procedures
Setting the Segments
d. s eg
d.seg (d.SEG): Change
0 the Display Segment
Selection from end to 0.
Press M
(Mode) Key
once.
sp
sp (SP): Segment 0 SP
40
time
time (time) Segment 0 Time
0.00
(Omitted.)
3
Press U
Key.
Press U
Key.
3 - 23