Table of Contents
Advertisement
Registering a Computer That is Connected
Register the name of the destination computer, IP address, and port number before using
Scan To Computer on the Network TWAIN.
Registering a Computer from the Operation Panel
Using Network Configuration (Windows Only)
Using the Network Scanner Setup Tool (Mac OS X Only)
Registering a Computer from the Operation Panel
You can register a computer on the same network as a scanning destination.
1.
Press [Device Settings].
2.
Press
or
3.
Press [Register] of a registration location.
To edit a registered group number, select [Edit].
4.
Enter a destination in [Destination].
5.
Enter a destination.
You can enter up to 16 characters.
6.
Press [OK].
7.
Press [Destination Address].
8.
Enter an IP address, host name, or computer name.
You can enter up to 64 characters.
9.
Press [OK].
10.
Press [Port No.].
11.
Enter a port number, and then press [OK].
12.
Press [Close] on a confirmation screen.
13.
Press [Back] until the home screen is displayed.
Using Network Configuration (Windows Only)
To change the computer name and IP address of your computer after the scanner driver is
installed, start the Network Configuration, select the driver, and then change the registered
several times to select [Network Scan Destination].
220
Advertisement
Table of Contents
