Setting A Binding Position For Duplex Scanning; Installing This Machine In A Computer; Checking That The Machine Is Connected To A Computer - Oki MC853 User Manual

Install this machine as a WSD Scan device with a Windows computer that supports WSD
Scan so that you can use the WSD Scan function.
Note
If a computer for WSD Scan recognizes this machine and the IP address of this machine is
changed, you must register from the beginning. Uninstall this machine, and then install it
again.
Before starting this installation, check that Network Search is enabled.
From [Control Panel], click [Network and Internet] > [Network and Sharing Center] >
[Change advanced sharing settings], select [Turn on network discovery] for [Network
discovery], and then click [Save Changes].
Memo
You can register up to 50 computers in this machine.

Installing This Machine in a Computer

1.
Select [Network] from the [Start] menu.
The devices that are connected to the network are displayed.
2.
Right-click the MC873 icon under [Multifunction Devices], and then
select [Install].
If the [User Account Control] dialog box is displayed, click [Yes].
3.
When a balloon message is displayed to inform you that the
installation is complete on the task bar, click the balloon to check
the details, and then click [x (Close)].
Check the device installation on the machine as follows.

Checking That the Machine is Connected to a Computer

1.
Press [Scan] or the
2.
Press [Scan To Computer].
3.
Press [Select A Connecting PC].
4.
Press [From WSD Scan].
5.
Check that a computer is displayed on this machine as a connection
destination of WSD Scan.

Setting a Binding Position for Duplex Scanning

To set a binding position for duplex scanning with Scan To Computer and Remote Scan via
(SCAN) button.
218