Table of Contents
Advertisement
Erasing Edge Shadows When Sending (Edge Erase)
A black shadow may be scanned around the edges of the scanned document. The edge
erase function allows you to erase the black shadow.
Memo
[Edge Erase] is set to [OFF] by factory default.
The default value of the edge width to erase can be changed from [Admin Setup] > [Fax
Setup] > [Default Settings] > [Edge Erase] > [ON] > [Width].
1.
Press [Fax/Internet Fax] or the
2.
Set a document in the ADF or on the document glass.
3.
Press [Fax].
4.
Press [Edge Erase] on the [Advanced] tab.
5.
Enter a value from 2 to 50 mm (0.1 to 2.0 inches) in [Width] by
using the 10-key pad or pressing
then press [OK].
Memo
If you press [Cancel], the screen returns to the previous screen without saving the
changes.
6.
Specify a destination.
Specifying a Destination (Direct Entry)
Specifying a Destination (Phone Book)
Specifying a Destination (One-touch Button)
Specifying a Destination (Transmission History and Reception History)
7.
Change other settings if necessary, and then press the
button.
Topics
(FAX) button.
on the touch panel, and
500
(START)
Advertisement
Table of Contents
