Oki MC853 User Manual page 978

Calling Timer
PBX Line
Forwarding Forwarding Setting
Setting
Forwarding Number
TAD Mode
Tel Priority Mode
CNG Detection
T/F Timer Programming
Soft Ringer Volume
Remote Receive Number
Range: 75, Pulse setting is TONE.
85, 100
mseconds
60 Displays only if Service Bit is ON.
mseconds,
Range: 1 -
255 seconds
OFF When connecting to PBX (internal
exchange), put it to [ON].
OFF Sets whether to enable the fax
forwarding mode.
(NULL) Sets a fax number used for the fax
forwarding mode.
Type 3 Sets an operation type in Tel / Fax
Ready mode.
[Type 3]: A fax signal is detected in
15 seconds from when the
answering machine answers.
Normally, use this type.
[Type 1]: A fax signal is detected
right after the answering machine
answers, and then the reception
starts. If you have any fax
reception problems, they may be
improved if this type is set.
[Type 2]: A fax signal is detected
right after the answering machine
answers. Set this type if you
usually use this machine as a
phone.
OFF Sets when the external telephone
and the machine ring in Tel / Fax
Ready mode.
[ON]: The sender is assumed to
make a voice call. The telephone
rings early.
OFF Sets whether to determine whether
the sender is sending a fax during
the off the hook condition in Tel /
Fax Ready mode.
35 seconds Sets when to start the auto fax
reception if the communication
does not start even after an
incoming call arrives in Tel / Fax
Ready mode or Ans / Fax Ready
mode.
High Sets a phone ring volume in Tel /
Fax Ready mode.
OFF Sets a remote switch over number.
977