Lift; Figure 71: Installing An Mpc Or Spc - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Reinstalling Cards After Installing the SRX5400 Services Gateway Without a Lift
Related
Documentation
156
To reinstall MPCs, SPCs, and the SCB, follow this procedure for each card (see
Figure 71 on page 156):
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Place the card on an antistatic mat or remove it from its electrostatic bag.
2.
Identify the slot on the services gateway where it will be installed.
3.
Verify that each fiber-optic has a rubber safety cap covering the transceiver. If it does
4.
not, cover the transceiver with a safety cap.
Orient the card so that the faceplate faces you.
5.
Lift the card into place and carefully align the sides of the card with the guides inside
6.
the card cage.
Slide the card all the way into the card cage until you feel resistance.
7.
Grasp both ejector handles and rotate them clockwise simultaneously until the card
8.
is fully seated.

Figure 71: Installing an MPC or SPC

Overview of Installing the SRX5400 Services Gateway Without a Mechanical Lift on
page 147
Tools Required to Install the SRX5400 Services Gateway Without a Mechanical Lift
on page 148
Removing Components from the SRX5400 Chassis Before Installing It Without a Lift
on page 148
Installing the SRX5400 Services Gateway Chassis in the Rack Manually on page 152
Copyright © 2017, Juniper Networks, Inc.