Switch Control Board Srx5K-Scb Specifications; Figure 42: Port Module Srx-Ioc-4Xge-Xfp Serial Number Label - Juniper SRX5400 Hardware Manual

Serial Number Location
Related
Documentation

Switch Control Board SRX5K-SCB Specifications

Copyright © 2017, Juniper Networks, Inc.
The serial number label is located as shown in

Figure 42: Port Module SRX-IOC-4XGE-XFP Serial Number Label

Cards Supported on SRX5400, SRX5600, and SRX5800 Services Gateways on page 29
Flex I/O Card (SRX5K-FPC-IOC) Specifications on page 60
The SRX5K-SCB Switch Control Board (SCB)
following functions:
Powers on and powers off I/O cards (IOCs) and Services Processing Cards (SPCs)
Controls clocking, system resets, and booting
Monitors and controls system functions, including fan speed, board power status, PDM
status and control, and the system front panel
Provides interconnections to all the IOCs within the chassis through the switch fabrics
integrated into the SCB
The SRX5400 Services Gateway supports only one SCB. The SRX5600 Services Gateway
has one SCB installed and you can install a second SCB for redundancy. The SRX5800
Services Gateway has two SCBs installed and you can install a third SCB for switch fabric
redundancy.
The host subsystem is composed of a Routing Engine installed directly into a slot on the
faceplate of the SCB. When there is no Routing Engine is a SCB, its slot must be covered
with a blank panel.
Chapter 4: Line Card and Module Description
Figure 42 on page
Serial number
ID label
JX0123
(Figure 43 on page
67.
68) performs the
67