Figure 11: Front Panel Of The Craft Interface; Table 4: Front Panel Of The Craft Interface; Srx5400 Services Gateway Craft Interface Alarm Leds And Alarm Cutoff/Lamp - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Related
Documentation
18

Figure 11: Front Panel of the Craft Interface

Table 4: Front Panel of the Craft Interface

Component Description
1 Routing Engine LEDs
2 Fan LEDs
3 PEM LEDs
4 Minor alarm LED
5 Major alarm LED
6 Alarm cutoff button
7 Alarm relay contacts
8/9 SCB and MPC LEDs, and MPC
online/offline buttons
The card LEDs are located along
the bottom edge of the craft
interface and are labeled
bottom slot reserved for the SCB
and
slots.
NOTE: The SCB must be installed in the services gateway for the craft
interface to obtain power.
Replacing the SRX5400 Services Gateway Craft Interface on page 249
SRX5400 Services Gateway Chassis on page 15
for the
0
, , and for the remaining
0/1 1 2
Reference
See "SRX5400 Services Gateway
Craft Interface Host Subsystem
LEDs" on page 19
See "SRX5400 Services Gateway
Craft Interface Fan LEDs" on
page 21
See "SRX5400 Services Gateway
Craft Interface Power Supply LEDs"
on page 20
See "SRX5400 Services Gateway
Craft Interface Alarm LEDs and
Alarm Cutoff/Lamp Test Button"
on page 19
See "SRX5400 Services Gateway
Craft Interface Alarm Relay
Contacts" on page 23
See "SRX5400 Services Gateway
Craft Interface Card OK/Fail LEDs"
on page 20
See "SRX5400 Services Gateway
Craft Interface Online/Offline
Buttons" on page 21
Copyright © 2017, Juniper Networks, Inc.