Modular Port Concentrator (Srx5K-Mpc) Specifications; Figure 21: Srx5K-4Xge-Xfp Serial Number Label - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Serial Number Location
Related
Documentation

Modular Port Concentrator (SRX5K-MPC) Specifications

44
The serial number label is located as shown in

Figure 21: SRX5K-4XGE-XFP Serial Number Label

OK /F AIL
Cards Supported on SRX5400, SRX5600, and SRX5800 Services Gateways on page 29
The SRX5K-MPC (see Figure 1 on page
MICs. These MICs add Ethernet ports to your services gateway. An MPC with MICs installed
functions in the same way as a regular IOC but allows you to add different types of
Ethernet ports to your services gateway. MPCs and MICs are similar in form and function
to Flex IOCs and port modules. However, the two use different form-factors, so you
cannot install port modules in an MPC, nor can you install MICs in a Flex IOC.
You must install at least one interface card in the services gateway. The interface card
can be of any of the available IOC, Flex IOC, or MPC types. You can add just one MIC; or
you can add two MICs of the same or different types.
You can install MPCs in any of the slots that are not reserved for Switch Control Boards
(SCBs).
If a slot in the SRX5400, SRX5600, or SRX5800 Services Gateway card cage is not
occupied by a card, you must install a blank panel to shield the empty slot and to allow
cooling air to circulate properly through the services gateway. If a slot in an MPC is not
occupied by a MIC, you must install a blank panel in the empty MIC slot to shield it and
to allow cooling air to circulate properly through the MPC.
Figure 21 on page 44.
Serial number
ID label
AA567 8
6) is an interface card with two slots that accept
Copyright © 2017, Juniper Networks, Inc.