Services Processing Card Srx5K-Spc-2-10-40 Specifications; Figure 14: Services Processing Card Srx5K-Spc-2-10-40 - Juniper SRX5400 Hardware Manual

Table 15: MPC and XFP Interoperability for SRX5400, SRX5600, and SRX5800
Devices (continued)
Model No.
SRX5K-MPC3-40G10G
SRX5K-MPC3-100G10G
Related
Documentation

Services Processing Card SRX5K-SPC-2-10-40 Specifications

Copyright © 2017, Juniper Networks, Inc.
SRX5K-4XGE-XFP
SRX5K-40GE-SFP
SRX5K-FPC-IOC
No
SRX5400, SRX5600, and SRX5800 Services Gateway Card Overview on page 28
The SRX5K-SPC-2-10-40 Services Processing Card (SPC) contains two Services
Processing Units (SPUs), which provide the processing power to run integrated services
such as firewall, IPsec, and IDP (see
gateway is passed to an SPU to have services processing applied to it. Traffic is
intelligently distributed by I/O cards (IOCs) to SPUs for services processing.
The services gateway must have at least one SPC installed. You can install additional
SPCs to increase services processing capacity.
You can install SPCs in any of the slots that are not reserved for Switch Control Boards
(SCBs). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the device.
Figure 14 on page 33 shows a typical SPC supported on the services gateway.

Figure 14: Services Processing Card SRX5K-SPC-2-10-40

Chapter 4: Line Card and Module Description
SRX5K-MPC
Yes
Figure 14 on page 33). All traffic traversing the services
SRX5K-MPC3-40G10G
SRX5K-MPC3-100G10G
Yes
33