Without A Lift; Figure 69: Reinstalling A Power Supply; Figure 70: Reinstalling The Fan Tray - Juniper SRX5400 Hardware Manual

Reinstalling the Fan Tray After Installing the SRX5400 Services Gateway Without a Lift
Copyright © 2017, Juniper Networks, Inc.
Chapter 18: Installing the SRX5400 Services Gateway Without a Mechanical Lift

Figure 69: Reinstalling a Power Supply

To reinstall the fan tray (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Grasp the fan tray on each side and insert it straight into the chassis. Note the correct
2.
orientation by the "this side up" label on the top surface of the fan tray.
Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
3.

Figure 70: Reinstalling the Fan Tray

Figure 70 on page 155):
155