I/O Card Srx5K-40Ge-Sfp Specifications; Figure 17: Serial Number Label (Ioc Shown, Other Cards Similar) - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Serial Number The serial number label is located as shown in
Location

Figure 17: Serial Number Label (IOC Shown, Other Cards Similar)

OK /F AIL
Related
Documentation

I/O Card SRX5K-40GE-SFP Specifications

40
Cards Supported on SRX5400, SRX5600, and SRX5800 Services Gateways on page 29
The SRX5K-40GE-SFP I/O card (IOC) is optimized for Ethernet density and supports 40
Gigabit Ethernet ports (see
forwarding and Ethernet interfaces on a single board, with four 10-Gbps Packet Forwarding
Engines. Each Packet Forwarding Engine consists of one I-chip for Layer 3 processing
and one Layer 2 network processor. The IOCs interface with the power supplies and
Switch Control Boards (SCBs).
You must install at least one IOC in the services gateway. The IOC can be of any of the
available IOC or Flex IOC types.
You can install IOCs in any of the slots that are not reserved for Switch Control Boards
(SCBs). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the services gateway.
Figure 17 on page 40.
Serial number
ID label
AA567 8
Figure 18 on page 41). The IOC assembly combines packet
Copyright © 2017, Juniper Networks, Inc.