Chassis - Juniper SRX5400 Hardware Manual

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Insert the bracket tab into the slot in the bottom center of the chassis.
4.
Align the bracket with the two mounting holes located toward the top center of the
5.

chassis.

There is no mounting hole in the center of the chassis that corresponds to the hole in
the center of the bracket.
Insert the two screws at the top of the bracket and tighten each partially.
6.
Two screws are needed for mounting the bracket on the center of the chassis. You
do not need the third screw.
Tighten the two screws completely.
7.
Repeat the procedure for the other bracket.
8.
Overview of Installing the SRX5400 Services Gateway on page 131
Site Preparation Checklist for the SRX5400 Services Gateway on page 92
Tools Required to Install the SRX5400 Services Gateway with a Mechanical Lift on
page 143
Unpacking the SRX5400 Services Gateway on page 133
Installing the SRX5400 Services Gateway Using a Mechanical Lift on page 143
Chapter 16: Installing the Mounting Hardware
141