Srx5400 Services Gateway Physical Specifications; Table 23: Site Electrical Wiring Guidelines - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Related
Documentation

SRX5400 Services Gateway Physical Specifications

90
WARNING: It is particularly important to provide a properly grounded and
shielded environment and to use electrical surge-suppression devices.

Table 23: Site Electrical Wiring Guidelines

Site Wiring Factor
Signaling limitations
Radio frequency interference
Electromagnetic compatibility
General Safety Guidelines and Warnings on page 319
General Electrical Safety Guidelines and Warnings on page 347
Prevention of Electrostatic Discharge Damage on page 348
Table 24 on page 91 summarizes the physical specifications for the services gateway
chassis.
Guidelines
If your site experiences any of the following problems, consult
experts in electrical surge suppression and shielding:
Improperly installed wires cause radio frequency interference
(RFI).
Damage from lightning strikes occurs when wires exceed
recommended distances or pass between buildings.
Electromagnetic pulses (EMPs) caused by lightning damage
unshielded conductors and electronic devices.
To reduce or eliminate RFI from your site wiring, do the following:
Use a twisted-pair cable with a good distribution of grounding
conductors.
If you must exceed the recommended distances, use a
high-quality twisted-pair cable with one ground conductor
for each data signal when applicable.
If your site is susceptible to problems with electromagnetic
compatibility (EMC), particularly from lightning or radio
transmitters, seek expert advice.
Some of the problems caused by strong sources of
electromagnetic interference (EMI) are:
Destruction of the signal drivers and receivers in the device
Electrical hazards as a result of power surges conducted over
the lines into the equipment
Copyright © 2017, Juniper Networks, Inc.