Srx5400 Services Gateway Grounding-Cable Lug Specification; Figure 56: Srx5400 Services Gateway Grounding Point; Figure 57: Grounding Cable Lug - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Related
Documentation

SRX5400 Services Gateway Grounding-Cable Lug Specification

108

Figure 56: SRX5400 Services Gateway Grounding Point

P E M 0
P E M 1
A IR
P E M 2
FI LT E R
To ground the services gateway, you must connect a grounding cable to earth ground
and then attach it to the chassis grounding point using the two screws provided.
NOTE: Additional grounding is provided to an AC-powered services gateway
when you plug its power supplies into grounded AC power receptacles.
SRX5400 Services Gateway Grounding-Cable Lug Specification on page 108
SRX5400 Services Gateway Grounding-Cable Specification on page 109
The accessory box shipped with the services gateway includes the cable lug that attaches
to the grounding cable (see
secure the grounding cable to the grounding points.

Figure 57: Grounding Cable Lug

End view
0.28
diameter
0.55
each hole
0.08 0.25 0.625
CAUTION: Before services gateway installation begins, a licensed electrician
must attach a cable lug to the grounding and power cables that you supply.
A cable with an incorrectly attached lug can damage the services gateway.
P E M 3
FA N
TR AY
Figure 57 on page 108) and two UNC 1/4–20 screws used to
2.25
Crimp area
0.37 All measurements in inches
6 AWG conductor
Copyright © 2017, Juniper Networks, Inc.