Table of Contents
Advertisement
SRX 3400 Services Gateway Getting Started Guide
Install the Device Without a Mechanical Lift
To install the device without a mechanical lift:
Remove Components
To make the services gateway light enough to install manually, you first remove most
components from the chassis as shown in Figure 9 on page 10 and
Figure 10 on page 11. The procedure in this section for removing components from
the chassis is for initial installation only and assumes that you have not connected
power cables to the services gateway:
Figure 9: Components to Remove from the Front of the Device
10
Step 3: Install the Device
Remove Components on page 10
Lift the Chassis into the Rack on page 11
Reinstall Components on page 12
Power supplies
Switch Fabric Board (SFB)
Routing Engine
I/O Cards (IOCs)
Network Processing Cards (NPCs)
Services Processing Cards (SPCs)
Fan tray
SFB
Cards in
CFM slots
Advertisement
Table of Contents
