Table of Contents
Advertisement
CNG Count
When set either in the T/F or TAD modes, the machine detects the type of signal
(calling tone, CNG) sent from the remote location and initiates fax reception if re-
quired. This function sets the CNG detection number. The available setting is 1-5
times (numeric keypad input). Speed access no. 65.
Ring Response
This function controls how long the machine waits before answering an incoming
call. The available settings are 1 ring, 5, 10, 15 and 20sec. Speed access no. 66.
Distinctive Ring
Distinctive ringing is a service offered by some telephone companies that allow dif-
ferent telephone numbers to be assigned to a single line, each number being assigned
a distinctive ring. When an incoming call is received, it is possible to identify the
number being call by the assigned ringing pattern. When set to ON, fax reception
begins only after a programmed ring pattern is detected. If no ring pattern has been
programmed, the ring pattern defined for each country is used for detection as the
default setting. Available settings are ON (detected), OFF (not detected) and SET
(programmed). Speed access no. 67
Note: The default setting (factory setting) is ON for the following countries only:
USA, DEN, GER, SUI, AUT, POR, AUS, NZL, SIN, HUG, ITA and MEX. All other
countries must learn the ring pattern using SET before being able to set the machine to
ON.
To Change Operation Functions
1 Press Menu/Exit to enter Menu.
2 Input the speed access number of the parameter to be changed, wait.
3 When the display for the desired parameter is shown, press
the setting (or input data where required), press Enter.
4 Press Menu/Exit to return to standby mode.
5 Repeat steps 1-4 until finished setting parameters.
or
to select
83
Advertisement
Table of Contents
