Konica Minolta FAX 9840 Instruction Manual page 85

ECM Function
The error correction mode (ECM) function is provided to improve communications in
areas where telephone line conditions are very poor. Available settings are ON and
OFF. Speed access no. 20.
Sender ID Switch
This function determines if the Sender ID is to be printed on the transmitted fax.
Available settings are ON and OFF. When ON, the ID is included on the fax. Speed
access no. 23.
Power Save Mode
When this function is set to ON, the machine will automatically switch to a low-
energy use mode after being idle for 10min. Available settings are ON and OFF.
Speed access no. 26.
Pulse Dial Rate*
If the machine is set to DP, this function controls the rate of the dialing pulses (which
vary by country). Available settings are 10, 16 and 20pps. Speed access no. 46.
Pulse Make Ratio*
If the machine is set to DP, this function controls the make rate of the dialing pulses.
Available settings are 33, 39 and 40%. Speed access no. 47.
Pulse Dial Type*
If the machine is set to DP, this function controls the type of pulse dialing it uses
(types of pulse dialing vary by country). Available settings are N, 10-N and N+1.
Speed access no. 48.
T/F Timer Prg.
When set to T/F, the machine will automatically distinguish between incoming voice
and fax communications. The T/F timer controls how long the machine waits for the
call to be answered before switching to FAX mode. Available settings are 20 and
35sec. Speed access no. 62.
82