Installation When Using Ethertalk; Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

Installation When Using EtherTalk

This section describes how to install the machine using EtherTalk.
The following shows the reference section for each procedure.

Step 1 Preparations................................................................................................................... 297

Step 2 Configuration on the Machine ...................................................................................... 297

Step 3 Configuration on the Computer .................................................................................... 298
CentreWare Internet Services Setting Items ............................................................................ 298
Step 1 Preparations
The following items are required to set up the machine to use the EtherTalk interface.
EtherTalk network environment
The Adobe PostScript 3 Kit (optional)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use EtherTalk on the machine.
Note • EtherTalk can be configured when the Adobe PostScript 3 Kit (optional) is installed.
• You can configure the settings using CentreWare Internet Services. For the items that can
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2
Enable the EtherTalk port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [EtherTalk], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3
Select [Close] repeatedly until the [Tools] screen is displayed.
4
Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
5
Print a configuration report to confirm that the EtherTalk port is enabled.
For information on how to print a configuration report, refer to "Print Reports" (P.87).
be configured using CentreWare Internet Services, refer to "CentreWare Internet Services
Setting Items" (P.298).
displayed on the screen, follow the message and reboot the machine.

Installation When Using EtherTalk

7
297