Table of Contents
Advertisement
Setting
DNS
Added Port
Number
Connect Time-Out
TBCP Filter
[EtherTalk Compat]
Network/Port
EtherTalk Compat
Setting
Port Status
PJL
Sets whether or not to use the name registered to the DNS (Domain Name
System) when identifying the printer.
• [Enabled] (default)
The DNS name is used.
• [Disabled]
The IP address is used.
Sets the additional port number from 1 to 65535. (See *2 on P. 188.)
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/
SOAP/UPnP/WSD ports and Internet services that use HTTP protocol can
share the same port number.
(See *6 on P. 188.)
Sets the time after which data reception is canceled if data is not received.
Specify the value from 0 to 65535 seconds in 1-second increments.
• [60 Seconds] (default)
Sets whether to enable or disable the TBCP filter during processing of
PostScript data.
• [Disabled] (default)
• [Enabled]
EtherTalk Compat
Port Status
EtherTalk Compat
PJL
Sets whether to enable or disable the EtherTalk port at printer start-up.
• [Enabled]
• [Disabled] (default)
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. (See *5 on P. 188.)
• [Enabled] (default)
• [Disabled]
Description
Description
5.2 Common Menus Setting
139
Advertisement
Chapters
Table of Contents
