Loading Paper In Tray 6 (Hcf) (Optional) - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

Loading Paper in Tray 6 (HCF) (Optional)

The following describes the procedure for loading paper into Tray 6 (HCF) (optional).
When the machine runs out of paper during copying or printing, a message is displayed
on the touch screen. Add paper according to the displayed instructions. Copying or
printing is automatically resumed when paper is added.
Note • Fan the paper well before loading paper in a tray. It prevents paper from sticking to each
For information about changing the paper size and orientation, refer to "Changing the Paper Size for
Tray 6 (HCF) (Optional)" (P.53).
1
Pull out the Tray 6 until it stops.
Important • While the machine is processing a job, do
• Do not add a new stack of paper on top of
2
Load and align the edge of the paper against
the right edge of the tray with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
3
Push the tray in gently until it stops.
Important • When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it
other and reduces paper jams.
not pull out the tray that the job uses.
the remaining paper in the tray to prevent
paper jams or any other troubles. First,
remove the remaining paper from the
tray, and then load the new stack of
paper.
line. It might cause paper jams or
machine malfunctions.
might cause machine malfunctions.
Loading Paper
2
49