Print Service Settings; Allocate Memory; Postscript Memory - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

Print Service Settings

In [Print Service Settings], you can configure settings related to the Print feature.
Using CentreWare Internet Services, you can make more detailed settings.
For more information, refer to "CentreWare Internet Services Settings" (P.269).
The following shows the reference section for each setting.

Allocate Memory...................................................................................................................... 189

Delete Form.............................................................................................................................. 191
Other Settings........................................................................................................................... 192
1
On the [Tools] screen, select [Print Service Settings].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.108).
2
Select an item to set or change.
Allocate Memory
For each interface, set the memory capacity of the receiving buffer (temporary storage
for data sent from the client).
You can change the receiving buffer capacity according to its use and purpose.
Increasing the receiving buffer capacity may allow a client to be released sooner from
an interface.
Important • If you change the capacity memory, the memory is reset, thus all data stored in memory
• You cannot allocate more memory beyond its memory capacity. When you turn the machine
Note • When a port is set to [Disabled], the corresponding items to the port do not appear.
• Depending on the amount of data sent from the client, increasing the memory capacity may

PostScript Memory

Specify a value for the PostScript memory capacity from 55.00 to 128.00 MB in 0.25 MB
increments.
Note • This feature does not appear for some models. An optional component is required. For more
• The maximum amount of memory you can allocate varies according to the amount of free
ART IV, ESC/P, 201H Form Memory
Displays where to save forms for use with ESC/P-K.
Note • This feature does not appear for some models. An optional component is required. For more
area is erased.
on, and the size set exceeds the total memory size, the system automatically adjust the
memory size.
not change the time taken to release the client.
information, contact our Customer Support Center.
space available in memory.
information, contact our Customer Support Center.

Print Service Settings

189
5