Notes And Restrictions For Print E-Mail - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

When the Scan to PC (FTP) service is used, only ASCII characters can be used for
file names.
In the following cases, since the addresses may not be recognized as those of the
same machine, the lpq command (for status check) and the lprm command (for
canceling) may not be available for LPD print jobs.
- When simultaneously operating IPv4 and IPv6 addresses with the same host
- When simultaneously operating multiple IPv6 addresses with the same host
IPv6 addresses may not be correctly recorded on job logs. Use an IPv4 network for
correct logging.
When searching a device outside the router via SMB, directly specify the address.
Multicasting is supported only within a local link (FF02::1).
In an IPv6 environment without a DNS server, if a computer name is specified in the
SMB server settings for SMB authentication, the authentication fails. Specify the
IPv6 address directly for a computer name of the authentication server.
If you specify an IPv6 address as a destination URL using a remote access service,
such as DocuShare, the address does not operate correctly. In an IPv6 environment,
use a DNS server and specify a remote service's destination URL by using the
FQDN.

Notes and Restrictions for Print E-mail

Print E-mail
The machine cancels receiving e-mails but does not display error codes when disk
space is insufficient.
Notes and Restrictions for Custom Paper
When copying cannot be made after an error code "024-747" is displayed on the
touch screen
If you select a tray in which Custom paper is loaded to make a copy, an error code "024-
747" appears on the touch screen, and copying may not be made.
In this case, take one of the following measures:
Select [Auto] in [Paper Supply].
Select a paper type other than Custom paper under [Tools] > [Common Service
Settings] > [Paper Tray Settings] > [Paper Tray Attributes] in the System
Administration mode.
Select [Enable for Same Paper Type, Weight & Color] under [Tools] > [Common
Service Settings] > [Paper Tray Settings] > [Auto Tray Switching] Control] > [Auto
Tray Switching] in the System Administration mode.
Notes and Restrictions
655
16