Step 4 Configuring The Sip Server - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

10 Using IP Fax (SIP)

Step 4 Configuring the SIP Server

This section describes the configuration procedures to set the IP address, login user
name, and password of a SIP server to go through.
Configure a SIP server when you use the IP fax (SIP) feature via a SIP server.
You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.273).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
Note
3) Select [Tools] on the [Services Home] screen.
2
Configure SIP server settings.
For more information on SIP server settings, refer to "SIP Settings" (P.175).
1) Select [Connectivity & Network Setup].
2) Select [SIP settings].
3) Select [Enable SIP Server], and then select [Change Settings].
4) Select [Yes], and then select [Save].
5) Select [SIP Server IP Address Resolution], and then select [Change Settings].
6) Select a method to obtain the SIP server IP address, and then select [Save].
7) Select [SIP Proxy Server Setup], and then select [Change Settings].
10
8) Set the IP address, port number, login user name, login password, and server type.
Note
9) Select [SIP Registrar Server Setup], and then select [Change Settings].
10) Set the IP address, port number, login user name, login password, and server type.
Note
11) Select [Close].
3
Select [Close] repeatedly until the [Tools] screen is displayed.
4
Select [Close].
Note
5
Print a configuration report to confirm that the SIP server settings.
For information on how to print a configuration report, refer to "Print Reports" (P.87).
336
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
• The default user ID is "11111".
• The default passcode is "x-admin".
• The settings of port number, login user name, login password, and server type are required
even when [SIP Server IP Address Resolution] is set to [DHCP] or [DHCP v6].
• The settings of the port number, login user name, login password, and server type are
required even when [SIP Server IP Address Resolution] is set to [DHCP] or [DHCP v6].
• Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.