Replacing Staple Cartridge (For Finisher-C1 Or Finisher-C1 With Booklet Maker) - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

3 Maintenance
Replacing Staple Cartridge (for Finisher-C1 or Finisher-C1 with Booklet
Maker)
When the Finisher-C1 (optional) or Finisher-C1 with Booklet Maker (optional) is
installed and the staple cartridge needs to be replaced, a message appears on the
touch screen. When this message appears, load a new staple case into the staple
cartridge.
This section explains how to replace the staple cartridge in the Finisher-C1 with Booklet
Maker, as an example. You can apply the same procedures to the Finisher-C1.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
Note
1
Make sure that the machine is not operating,
and open the finisher front door.
3
2
Grasp the handle [R1] of the staple cartridge
holder, and pull out the holder to the right,
towards you.
3
Pull the staple cartridge out of the finisher.
Note
4
Pinch both sides of the empty staple case
with your fingers (1), and remove the staple
case from the cartridge (2).
68
performance. Use only staple cartridges recommended by Fuji Xerox.
• To order a staple cartridge, contact our Customer Support Center.
• The staple cartridge is firmly inserted. A
slight force is required to pull the cartridge
out of the finisher.
[R1]
2
1
1